The DB9F-TO-TB/10 Adapter is plugged into a serial connector DSub-9 male, like Com1 on a PC. The signals located on the Pins then are available on the clamps of a Terminal block.
The signal location is optimized for RS422/485 serial ports and CAN bus on VScom products. GND, Rx+/- and Tx+/- (Data+/- for RS485) are on the clamps. This also applies to CAN bus CAN_H and CAN_L signals.
The housing provides for isolation and strain relief on the cables, additional screws easily fix the adapter to a DSub-9 male connectors. Use without housing is possible for frequent access to the terminal block.
⇒ Read more …